Technical Specification For PS-AMP
|
|
Analogue Outputs: |
2 x speaker connectors (2 each black and red terminals)
1 x ¼ inch (6.35mm) stereo jack headphone socket |
|
Headphones Output: |
Drives 150mW into 32Ω to 600Ω stereo headphones |
|
Headphone Level Range: |
-60dB – 18dB via front panel control knob or optional IR controller |
|
USB Port: |
1 x USB A socket |
|
Frequency Response: |
20Hz - 20kHz using MP3 at a bit rate of 192kbps and above |
|
GPOs (General Purpose Outputs): |
2 x switchable relay contacts (simultaneously switched) controlled from PS-SEND |
|
Serial Port: |
1 x 9 way D-type socket, used to send control commands and update firmware |
|
Ethernet Port: |
1 x RJ45 socket. Remote control commands can be sent via TCP or UDP as well as firmware updates. |
|
IR Remote Receiver: |
Remote commands can be sent using optional remote control via built in IR sensor |
|
Speaker Power: |
15W per channel into 8ohm @ 10% THD+N |
|
Mains Input: |
Filtered IEC, 85 - 264VAC, 47 - 63 Hz, 60W max |
|
Fuse Rating: |
Anti-surge fuse 1A 20 x 5mm |
|
|
|
Audio Codec Specifications Decoder
G.711 (U Law/A Law 8kHz to 48kHz sampling rate)
WAV (IMA ADPCM+ 16bit PCM uncompressed: 8kHz to 48kHz)
MP3 MPEGv1 Layer 3 (32, 44.1 and 48kHz, CBR +VBR +ABR)
MP3 MPEGv2 Layer 3 (16, 22.05 and 24kHz, CBR +VBR +ABR)
Ogg Vorbis (floor 1) |
Supported Network Transport Protocols
RTP - UDP
HTTP - TCP
Raw UDP
Raw TCP
SNMP - traps for remote management
DHCP, BOOTP, IPZator or AUTOIP - Dynamic IP address resolution
SonicIP IP Address readout |
|
|
|
Physical Specification
|
Dimensions (Raw): |
22cm (W) x 13.7cm (D) x 4.3cm (H)
8.67” (W) x 5.39” (D) x 1.7” (H) |
Dimensions (Boxed): |
34cm (W) x 27cm (D) x 6cm (H)
13.4” (W) x 10.6” (D) x 2.4” (H) |
Weight: |
Nett: 0.84kg Gross: 1.64kg
Nett: 1.85lbs Gross: 3.6lbs |
